[Snap] Page on [Options] Dialog Box
On [Snap] page on [Options] dialog box, you can modify the following settings.
Snap Shape
[Snap enabled]
Turn it on to enable shape snap. Turn on the check box of a shape for which snap is to be enabled. Input the divided number for the equally dividing point.
[Snap to Layer with [Show Only] or Shape on Part Drawing.]
Turn it on to enable snapping shapes on the layer or part drawing with the status of "Show Only."
[Do Not Snap To Auxiliary Dimension Line]
Turn it on to disable snapping to auxiliary dimension lines.
[Snap cursor to snap point]
Turn it on to move the cursor to snap point. It does not move to Neighbor Point, Horizontal and Vertical Line, Shape Extension Line, and Shape Perpendicular Line.
Snap angle
[Enable Snap Angle]
Turn it on to enable angle snap.
Select [Snap only when an angle is contained in a snap box.] to snap to the angle nearest to the center of the snap box among intersection angles within the snap box. When there are no intersection angles, snap cannot be performed.
Select [Snap to the Nearest Angle] to snap to the angle nearest to the center of the snap box even when there are no intersection angles within the snap box.
[Angle]
Set the basic angle for angle snap.
Grid
Select [Snap only when a grid point is included in a snap box.] to snap to the grid point nearest to the center of the snap box among those within the snap box. When there are no grid points, snap cannot be performed.
Select [Snap to the Nearest Grid Point] to snap to the grid point nearest to the center of the snap box even when there are no intersection angles within the snap box.